Vehicle manual Peugeot 308

Disconnect the charge cable from the vehicle
Open the vehicle with the Mobility Card (hold it up to the checkpoint).
After opening the vehicle, the charging cable is unlocked, pull out the charging cable and attach it to the charging station.
If the cable needs to be taken with you (marked on the charging cable), place it in the vehicle.
If the charging cable has been locked again, press the Open door lock button on the switch in the driver’s door to interrupt the charging process and remove the charging cable on the side of the vehicle.
Setting off
If you haven’t already done so, log in at the checkpoint with your Mobility Card. To start the vehicle, press the brake and press the start button.
Please note: It may be that too much time elapses between the first time you log in with the card and the time you set off. In this case, hold the Mobility Card up to the card reader again.
When the “READY” indicator light comes on, the vehicle is ready to drive (noiseless). Otherwise, repeat the process. The handbrake may have to be released.
Engage gear “D” (normal forward gear) or “R” (reverse) as required, always keeping the brake depressed.
On the road
The motor of an electric car is virtually silent. Up to 30 km/h, however, the vehicle generates a synthetic sound to alert pedestrians.
ECO+ mode – Range
ECO+ mode (“ECO/ECO+” button in the lower section of the centre console) is a function that optimises the range of the vehicle. It affects certain on-board systems such as the air conditioning and power steering. An anticipatory driving style also increases the range.
Driving position “B”
In driving position “B”, the motor braking effect is more marked. This helps charge the battery more during deceleration (braking).
Range according to the WLTP test cycle: 410 km
Range under normal driving behaviour: 328 km
Please note: if the range is less than 20 km, the vehicle must be driven to a charge point immediately.
After completing your journey
Park the vehicle in reverse at the Mobility parking space – the charging socket is located on the right-hand side at the rear. Engage driving position P (parking) and press the start button to switch off the vehicle.
Take the charging cable from the charge point and insert it into the vehicle.
Lock the car with the Mobility Card (hold card up to the checkpoint).
The charging process starts automatically. Check this on the indicator at the charging socket. This has to be flashing green if the car is being charged properly.

charging en route

Locations of Swisscharge rapid charge points
On-the-go charging at a rapid charge point
Engage driving position P (park), pull the hand brake and switch off the car.
Open the charge flap.
Remove the rubber caps from sockets “1” and “2” under the charge flap.
Take the charging cable from the DC charging station and plug it into the sockets. Start the charging process with the charging card in the vehicle’s glove box. To do this, follow the instructions on the charging station display. If you have any problems, contact the number at the charging station.
Range after 20 minutes of rapid charging at maximum charging rate ~ 60 km
Time required for 80% charge ~ 55 mins
The vehicle has two sockets under the charge flap:
Upper connection “1” = AC charging, e.g. as at the Mobility station
Upper socket “1” and lower socket “2” combined = DC rapid charging.
{ "_attributes": { "type": "text" } }
On-the-go charging – Type 2 AC charge point
Proceed as for charging at a rapid charge point. To charge at a Type 2 charge point, only flap “1” has to be removed. In some cases, the charge cables are permanently connected to the charge point; otherwise use the charging cable in the boot of the vehicle. Don’t forget to take it with you when you’ve finished.
Depending on the provider, the charging process is started automatically via an app or payment by credit card (the customer can bill Mobility if payment by credit card is required). The charging card in the glove compartment of the vehicle can also be used. If necessary, contact the charge point provider.
If the charging session has been started correctly, charging indicator “3” at the vehicle socket flashes green. Check this is the case.
Range after 20 minutes of Type 2 AC charging at maximum charging rate: ~ 16 km
Time required for 80% charge ~ 3 hours ~ 30 mins
{ "_attributes": { "type": "text" } }
Additional charging cable
If there are no charging cables at a charge point, you’ll find one in the boot of the vehicle. This is compatible with charge points which have a Type 2 socket. Don’t forget to put it back in the car boot after charging.
If the charging session has been started correctly, charging indicator “3” at the vehicle socket flashes green. Check this is the case.
{ "_attributes": { "type": "text" } }